bay
rotate_plate
rp
Trendsetter_400/800_Auto
The rotate_plate parameter is used to selectively enable the plate rotator.
This state parameter is not normally modified with the 'set' command. The
firmware uses this parameter for internal 'housekeeping'.
Print Console V2.0 or higher:
This parameter will be updated as part of the load bay command. It should NOT be
set manually.
If this parameter is set to 0, then the plate will NOT be rotated before being fed
into the processor.
If this parameter is set to 1, then the plate WILL be rotated 90 degrees before being
fed into the processor.
Allegro workstation software:
This parameter must be set through diagnostics, and that setting will be used on all plates.
If this parameter is set to 0, then the plate will NOT be rotated before being
fed into the processor.
As of firmware V1.40:
If this parameter is set to 1, then the firmware will always present the shortest
edge to the processor. Plates loaded in portrait will not be rotated; plates loaded
in landscape will be rotated 90 degrees prior to being fed into the processor.
If this parameter is set to 2, then ALL plates will be rotated 90 degrees prior to
being fed into the processor.
Prior to firmware V1.40:
If this parameter is set to 1, then the plate WILL be rotated 90 degrees before being
fed into the processor.
uint8
1
0 to 2
This parameter will automatically be copied into "state plate_loc" when a plate is picked.
state